Value System 2 - Open Loop 110 Volt, Temperate Climate
(With SRCC OG-100 Collectors - Qualifies for Federal Tax Credit) |
| |
|
|
| |
Value System 2 has a 110 Volt circulator controlled by a Differential Controller with 2 sensors, built in re-circulation light freeze protection and duel Digital Temperature readouts. It is for use in areas with no freeze or very light freeze.
|
|
| |
|
|
| |
This system circulates potable water through the collectors and then returns the solar heated water into the storage tank. The standard configuration used a "Quick Connect" that replaces the drain at the bottom of the tank with a "coaxail" fitting. This fitting allows the solar collector's feed and return line to share the same hole.
|
|
| |
|
|
| |
Returning solar heated water goes through a center tube into the tank. The warmer solar heated water immediately rises and at the same time cool water is being sucked by the solar pump through the space around the hot return tube.
|
|
| |
| |
System 2 is an open loop system with traditional 110 Volt pump and differential control like offered on many other sites. The big difference is that it is much easier to install and far more complete than systems offered on other sites.
|
|
| |
| |
Temperate System 2 Features: |
|
| |
|
|
| |
•110 Volt Pump with Digital Readout Differential Control with line cords |
|
| |
•Light Weight, Easy to install collectors with all copper high performance absorbers |
|
| |
•All solar Loop Parts and Fittings Included except tubing. |
|
| |
•Complete "Easy Mount" rail system |
|
| |
•No Soldering Required for the entire solar Loop |
|
| |
•Choice of "Stacked" or "Side by Side" collector layouts |
|
| |
•"Quick Connect" to bottom of tank or optional Top Connects available |
|
| |
•"Choice of 2 Standard and 24 Optional Collector Trim Colors |
|
| |
•A choice of options to make the system just right for you |
|
| |
|
|
| |
Temperate System 2 Parts List: |
|
| |
|
|
| |
• 10 or 20 sq. ft solar thermal collector(s), 20” wide x 6’ or 12’ long
• Rail flush mounting kit
• 110 Volt Pump with line cord
• Differential Controller with line cord and 2 sensors (with built in Re-circulation Freeze Protection)
• Compression unions
• Lag screws
• Washers
• Tec screws
• 6’ sample section of high temp insulation
• “Quick Connect” Kit for existing or added water heater with shut off and drain valves
• Floating ball check valve (“Bottom Connect” is standard, “Top Connect” (TC02) is available at $60.00 extra charge)
• Solar Loop Pressure Relief Valve (PRV)
• Air vent with pre-soldered assembly
• Installation and Owner’s Manuals. |
|
| |
| |
Not Supplied: Storage Tank, 50' roll of copper tubing, water side plumbing, Tempering valve, Insulation. |
|
