Previous Page
Total: $0.00

Premium System 3 is 100% Run by the Sun! It has a 12 Volt circulator that is powered by a Photovoltaic Panel, it has two forms of light freeze protection and is for use in areas with light freeze

This system circulates potable water through the collectors and then returns the solar heated water into the storage tank. The standard configuration used a "Quick Connect" that replaces the drain at the bottom of the tank with the "coaxial" fitting.

This fitting allows the solar collector's feed and return line to share the same hole. Returning solar heated water goes through a center tube to the tank. The warmer heated water immediately rises and at the same time cool water is being sucked by the solar pump through the space around the hot return tube. This system is so complete, it even includes FREE 36' of High Temperature insulation.

"Skyline" Premium: The Most Complete Solar Water Heating Kits in the World!
Click here for the System 3 Installation Manual
Click here for the System 3 Top Connect Diagram
Click here for the System 3 Bottom Connect Diagram
Click here for the System 3 Two Tank Diagram
Click here for the System 3 Owner's Manual

Temperate System 3 Features:

  • 12 Volt Pump with Photovoltaic Panel
  • Light weight, easy to install collectors with all copper high performance absorbers
  • Complete "Easy Mount" rail system
  • Dole Freeze Valve that opens at 45 degree F for very light freeze protection
  • Recirculation Freeze Protection Standard - 12Volt Freeze Snap Switch Control Box w/ Transformer
  • Digital Twin Temperature Readout with sensors, tape, & a spare set of batteries
  • All solar Loop Parts and Fittings Including pre-soldered assemblies
  • 50' roll of soft copper tubing with compression unions and Ells
  • FREE 36' of 1/2" wall high temperature insulation
  • Tempering Valve (3/4 " C x C x C) also no solder TemperingValve Options
  • No soldering required for the entire solar loop
  • "Quick Connect" to bottom of tank or optional Top Connects available
  • FREE Option: Choice of "Stacked" or "Side by Side" collector layouts
  • Choice of 2 Standard and 24 optional Collector Trim Colors
  • A choice of options to make the system just right for you

Temperate System 3 Parts List:

  • 10 square foot solar thermal collector(s), 20" wide x 6' long
  • Rail flush mounting kit with lags
  • System dependant 12 Volt Laing circulation pump
  • 5, 10, or 20 watt PV panel with 25' of wire
  • Dole Freeze Valve with fittings that opens at 45 degree F
  • Recirculation Freeze Protection with 12Volt snap switch control box & transfomer/wiring
  • 50' roll of 1/2" OD soft copper
  • Compression unions, lag screws, washers, tec screws
  • 36' of 1/2" wall high temp insulation
  • "Quick Connect" Kit for existing or added water heater with shutt off and drain valves
  • Floating ball check valve ("Bottom Connect" is standard, "Top Connect" (TC04) is available at a $195 extra charge)
  • Solar Loop Pressure Relief Valve (PRV) with splash guard
  • Air vent with pre-soldered assembly
  • Temperature guages
  • Tempering valve (20s/f and above)
  • Special OG-300 labeling
  • Installation & Owner's Manuals
    NOT Supplied:
  • Storage Tank (except with TC80FL option)
  • Water side plumbing
  • This configuration is designated as "F3"
High Temperature Snap Switch (H180)
Snap Switch (S110)
Quad Flow Diverter (QF34)
Digital Twin Temperature Readout (DTT1)
Temperature Gauge (TG01)
High Temperature Insulation (IS12)
High Temperature Insulation (IS34)
Please Note: Some of the above photos are System Options, and are NOT included in the system.
Temperate System 3
Model #
Price
(2) 10-01 (20 ft2) for 1 to 2 people, requires a 50 gallon tank
$1,948.00
(3) 10-01 (30 ft2) for 3 to 4 people, requires a 50 gallon tank
$2,198.00
(4) 10-01 (40 ft2) for 3 to 5 people, requires a 50 gallon tank
$2,478.00
(6) 10-01 (60 ft2) for 5 to 7 people, requires a 50 gallon tank
$2,995.00
Collector Configuration Options
Standard Color: Musket Brown (a dark architectural brown)
$0.00
Standard Color Option: Musket Brown (a dark architectural brown)
$0.00
Optional Trim Colors: Choose from one of 24 Optional Colors
$85.00
Stacked Collector Array Installation Kit (w/ system purchase)
$0.00
Side by Side Collector Array Installation Kit (w/ system purchase)
$0.00
Substitute One 20-01 Collector for every two 10-01 collectors
$0.00
Temperate System 3 Options
Additional 50 foot roll of 3/8" ID, 1/2" OD soft copper tubing
$2,045.00
Solar Top Connect with Tempering Valve
$195.00
Top Tempering Valve Assembly
$135.00
180ºF High Temperature snap switch
$22.00
110F Normally Closed Snap Switch
$32.00
Quad Flow Diverter
$84.00
Digital Twin Temperature Readout
$78.00
250F 2" Temperature Guage with 1/2" MPT fitting
$38.00
High Temp Insulation Solid 1/2" wall for 1/2" tube x 6' long
$9.75
High Temp Insulation Solid 1/2" wall for 3/4" tube x 6' long
$13.00
Store Contact: store@solarroofs.com
top of page
 
All prices & specifications are subject to change without notification. Shipping cost may not
be included, unless stated. Other custom collector combinations available upon request.