Previous Page
Total: $0.00

Value System 4 has a 110 Volt circulator controlled by a Differential Controller with 2 sensors, and dual Digital Temperature readouts. It is for use in areas with Hard Freeze.

This closed loop system circulates a special Non-toxic Propelene Glycol Antifreeze solution through the collectors and then through the collectors and then thru a Heat Exchanger either in or attached to a storage tank. This system is available in several configurations to meet special needs.

In addition to the standard system which is set up to use a heat exchange tank like the Rheem|Rudd HE, special configurations using a "Power Rod" external heat exchanger are available. A special PV powered version of the "Power Rod" is also available. The "Power Rod" is easily connected to a standard water heater.

This system is a closed loop system with a traditional 110 volt pump and differential control like offered on many other sites. The big difference is that it is much easier to install and far more complete than systems offered on other sites. Our "Power Rod" External Heat Exchanger (PR) is a double wall Tube & Shell.

Click here for the System 1 Installation Manual

Click here for System 4 One Tank Diagram

Hard Freeze System 4 Features:

  • 110 Volt Pump with Digital Readout Control with line cords
  • Light weight, easy to install collectors with all copper high performance absorbers
  • Complete "Easy Mount" rail system
  • Choice of Freeze Protected Closed Loops
  • Option: Easy Install High Efficiency Power Rod 2 pump Heat Exchanger
  • All solar loop Parts & Fittings including pre-soldered assemblies
  • No soldering Required for the entire solar loop
  • Choice of 2 Standard and 24 optional Collector Trim Colors
  • A choice of options to make the system just right for you

Hard Freeze System 4 Parts List:

  • 10 square foot solar thermal collector(s), 20" wide x 6' long
  • Rail flush mounting kit with lags
  • Differential Controller with line cord and two sensors (with built-in Re-circulation freeze protection)
  • Compression Unions, Lag screws, Washers, Tec screws
  • 6' sample section of high temperature insulation
  • Choice of "Quick Connect" Heat Exchange Kits for existing or added water heater with shut off and charge / drain valves
  • Floating ball check valve
  • Solar Loop Pressure Relief Valve (PRV)
  • Coin vent with pre-soldered assembly
  • Installation and Owner's Manuals
    NOT Supplied:
  • Water side plumbings
  • Storage tank (Internal Heat Exchanger Tank can be purchased separately under options)
  • 50' roll of copper tubing
  • Insulation
  • Tempering valve
  • Propylene Glycol.
Hard Freeze System 4 (For 80 or 120 HE Tank)
Model #
Price
(3) 10-01 (30 ft2) for 1 to 3 people (80 gallon HE tank)
$1,595.00
(4) 10-01 (40 ft2) for 3 to 5 people (80 gallon HE tank)
$1,895.00
(5) 10-01 (50 ft2) for 3 to 5 people (80 gallon HE tank)
$2,095.00
(6) 10-01 (60 ft2) for 4 to 6 people (80 - 120 gallon HE tank)
$2,345.00
(8) 10-01 (80 ft2) for 6 people + SSCI Only (120 gallon HE tank)
$2,845.00
Hard Freeze System 4 (For "Power Rod" Copper Heat Exchange & 2, 110V Circulators)
(3) 10-01 (30 ft2) for 1 to 3 people (50 - 60 gallon tank)
$2,195.00
(4) 10-01 (40 ft2) for 3 to 5 people (80 gallon tank)
$2,445.00
(5) 10-01 (50 ft2) for 3 to 5 people (80 gallon tank)
$2,695.00
(6) 10-01 (60 ft2) for 4 to 6 people (80 - 120 gallon tank)
$2,945.00
(8) 10-01 (80 ft2) for 6 people + SSCI Only  (120 gallon tank)
$3,445.00
Special PV Powered "POWER ROD" External Heat Exchanger (PRPV) for non-self cleaning 50 to 120 Gallon Tanks:
It doesn't get any easier than this! This Kit allows you to easily connect a closed loop to any standard (non self-cleaning) water heater! Kit includes a very efficient double wall* Tube in Shell Type Heat Exchanger with two 12 Volt PV Circulators and two PV Panels, Quick Connect Kit for installation to any standard tank. FREE! Solar Loop digital temperature gauges, Tempering Valve, and 50' roll of 1/2" OD Soft Copper.
Hard Freeze System 4 (For "Power Rod" Copper Heat Exchange & PV Panel)
(3) 10-01 (30 S/F) for 1 to 4 people (50 - 60 gallon tank)
$2,625.00
(4) 10-01 (40 S/F) for 3 to 5 people (80 gallon tank)
$2,875.00
(5) 10-01 (50 S/F) for 3 to 5 people (80 gallon tank)
$3,215.00
(6) 10-01 (60 S/F) for 4 to 6 people (80 - 120 gallon tank)
$3,465.00
(8) 10-01 (80 S/F) for 6 people + SSCI Only  (120 gallon tank)
$3,865.00
Collector Configuration Options
Standard Color: Musket Brown (a dark architectural brown)
$0.00
Standard Color Option: Musket Brown (a dark architectural brown)
$0.00
Optional Trim Colors: Choose from one of 24 Optional Colors
$85.00
Stacked Collector Array Installation Kit (w/ system purchase)
$0.00
Side by Side Collector Array Installation Kit (w/ system purchase)
$0.00
Substitute One 20-01 Collector for every two 10-01 collectors
$0.00
Hard Freeze System 4 Options
50 foot roll of 3/8" ID, 1/2" OD soft copper tubing
$98.00
Tempering Valve (3/4” C x C x C)
$98.00
Top Tempering Valve Assembly
$185.00
180ºF High Temperature snap switch (place on cold in) Opens 180ºF
$22.00
Quad Flow Diverter (with 4 - ¾” solder connections for duel tanks)
$84.00
Digital Twin Temperature Readout with sensors, tape, & batteries
$78.00
250º F 2" Temperature Gauge with ½” MPT fitting
$38.00
Insulation:  High Temperature Solid 1/2" wall for 1/2" tube X 6' long
$9.75
Insulation:  High Temperature Solid 1/2" wall for 3/4" tube X 6' long
$13.00
Double Wall “Power Rod” Quick Connect 
$178.00
Rheem | Rudd | Richmond   80 Gallon  81V080HE1 tank, Delivered
$1,565.00
Rheem | Rudd | Richmond 120 Gallon  82V120HE1 tank, Delivered 
$1,895.00
1 Gallon of Heavy Duty Propylene Glycol For down to -54 F
$26.00
Click here to e-mail us!
top of page
 
All prices & specifications are subject to change without notification. Shipping cost may not
be included, unless stated. Other custom collector combinations available upon request.